How to Drain and Refill the Plunge All-In

Drain and Refill

1. Pause the Cold Plunge and wait 1 minute. Ensure the jets have stopped.
2. Turn off the Cold Plunge by unplugging the power cord or pressing the “test” button. Do not drain the tub while the tub is paused. This can cause potential damage and void your warranty.
3. Remove the ventilation screen on the side opposite of the filter housing. 
4. Remove the cap from the spigot
5. Attach a garden hose to the spigot 
6. Turn the spigot on and the water should flow out. Note: gravity and length of the hose will effect how quickly the water drains out. 
7. Replace the cap after draining
8. Take this time while the Cold Plunge is empty to clean the drain strainers by following these instructions
9. Refill the Cold Plunge and follow the initial setup instructions

Frequency Requirements:

• Deeptime All-In
  • Every 6 months at minimum if you are following the chemicals protocols
  • Every month if you choose not to use a chemical protocol
    

Video Instruction: