Caring for Your Deeptime Chiller Series

We're thrilled that you are enjoying the Deeptime! To keep it running smoothly and the water sparkling clear, here is the guide on how to take care of your Deeptime. Remember, skipping the maintenance steps will damage your Deeptime and even void its warranty, so let's keep it in tip-top shape together!

This article is for the following tubs: 

• Deeptime Fiber Core Tub
• Deeptime Air Core Slant Tub

Please note: these recommendations are the minimum requirement. If you have the Cold Plunge outside and notice more dirt or water changes you may need to service the unit more frequently than what is recommended here. These recommendations are for residential use only. 

Every 2 Days at Minimum:

• Clear the water of debris using the skimmer net. 
• Clear any debris from the drain screens.
• Wipe film at the water line. 
• To keep your Plunge water safe and clean, see below for a protocol we recommend. This is a protocol that we’ve seen work well for most situations. Please keep in mind that water chemistry can be different based on the quality of your water in your jurisdiction.
  If you are on well water, please make sure you have the ability to properly reduce calcium levels before filling the tub. High amounts of calcium can damage the pump over time.

  Poor water quality can lead to skin infections, ear infections, and urinary tract infections. That's why it's important to monitor and manage the quality of the water routinely.

  These water maintenance instructions are meant to be used alongside the regular maintenance protocols for your Plunge. For more guidance, please email support@deeptime.cool.

Every Week at Minimum

• Clean Hair Catch
  • Failure to clean the hair catch weekly may result in reduced water flow, potentially causing damage to your Deeptime Chiller's system.
    

  • Cleaning the Hair Strainer (Every Week At Minimum)

    1. Turn off your chiller and double-check that there are no jets running.  
    2. Close the two colored ball valves on either side of the hair strainer on connection B by turning them perpendicular to the connection. 
    3. Carefully unscrew the hair strainer housing and remove the metal strainer. Please be aware that about a cup of water will come out when you remove the housing. If you have your chiller indoors, place a towel underneath and make sure you have it on a waterproof surface. 
    4. Rinse the metal strainer off, making sure all dirt and debris is removed. 
    5. Replace the metal strainer and screw the hair catch housing back on. Hand tighten and do not cross thread.
    6. Open the colored ball valves by turning them parallel to the connection. Do not turn the Cold plunge back on with the ball valves closed. 
    7. Turn the chiller back on.

Every Month at Minimum:

• Change Your Filter 
  
  • Failure to change your filter regularly may result in reduced water flow, potentially causing damage to your Evolve Chiller's system.

  • Changing the filter 

    1. Turn off your Standard Chiller, then double-check that there are no jets running. 
    2. Close all three colored ball valves by turning them perpendicular to the chiller connections. (Only close the ball valves when the chiller is fully off)
    3. Using the filter wrench, slide it onto the clear filter housing and unscrew it. Please note that some water may come out. 
    4. Remove the dirty filter and put a clean filter in. Please go here if you need filters. 
    5. Replace the filter housing, making sure not to cross thread it when you screw it back on. Please hand tighten only. 
    6. Open all three colored ball valves back up by turning them parallel to the tub. 
    7. Unlock the chiller UI and press the power button to turn the chiller back on. 

    Frequency Requirements: 

    Please note: If you do not follow the frequency requirements for your tub set up your warranty could be voided.